ROBUST CHASSIS
The larger the machine and the more powerful the engine, the more extreme the conditions it faces. It's no coincidence that the E750 features a fully welded chassis made of 3mm sheet steel, which has also been further reinforced at critical points.
KNIFE CHOICE
In addition to the classic fixed blades of ELIET scarifiers, ELIET has developed two other blade types specifically for professional users. These fixed and Double Cut™ blades also benefit from the unique properties of PPM™ technology. The choice is yours!
VERTICAL BELT TENSION
To disengage the blades, ELIET doesn't use a traditional tension pulley, which frequently causes malfunctions. Instead, ELIET developed the "vertical belt tensioner." A lever mechanism lifts the motor plate, tensioning the belt. This allows the belt to retain its natural shape even under load, significantly extending its lifespan. The two pulleys engage only the inside of the belt, protecting the outside of the belt from wear. Therefore, belt replacement on a professional ELIET scarifier is very rare.
DEPTH ADJUSTMENT ON REAR WHEELS
ELIET guarantees that the Permanently Sharp Blades™ will not wear down even after 100 hours of operation. The depth adjustment on the front wheels is insufficient to wear down the full length of the blade. Therefore, the E750 also has depth adjustment on the rear wheels.
ALU WHEELS
The large aluminum wheels on the E750 are of very high quality. The 20 mm axles are impact-resistant. Thanks to the double ball bearings on each wheel, you'll barely notice the machine rolling over grass. The wide rubber tread ensures that this scarifier leaves little to no marks on the lawn.
WHEEL SCRAPERS
Moss and soil raked out constantly stick to the wheels, causing the machine to bounce across the lawn. This makes driving difficult and reduces the machine's efficiency. ELIET provides standard wheel scrapers that prevent dirt from sticking to the wheels.
STEEL SHIELD COVER
Every 2 cm, a blade rakes the lawn. It's therefore logical that a layer of soil and other debris is removed from the ground. To protect the operator from any stone chips, ELIET therefore opted for a steel protective cover.